eth0 Warning

Subject: eth0 Warning
From: Simon, Daniel (dsimon@unf.edu)
Date: Fri Dec 15 2000 - 15:31:06 MST

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Next message: Stefan Jeglinski: "Re: XFree86-4.0.1 & ati"
• Previous message: Hollis R Blanchard: "Re: XFree86-4.0.1 & ati"
• Next in thread: Simon, Daniel: "FW: eth0 Warning"

Hey,

        Need some advice. I am getting the following at the end of my
bootup:

eth0 PHY ID: 0x00206047
eth0 Warning ! Unsupported BCM5400 PHY !

Then I get:

eth0 PHY reset timeout
eth0 Warning ! Can't find PHY

about 5 - 6 times over.

I am using a G4 -- I of course don't get IP or any network protocols. Can't
ping, etc.
Any advice would be great.

Thanks,

Dan Simon

• Next message: Stefan Jeglinski: "Re: XFree86-4.0.1 & ati"
• Previous message: Hollis R Blanchard: "Re: XFree86-4.0.1 & ati"
• Next in thread: Simon, Daniel: "FW: eth0 Warning"

This archive was generated by hypermail 2a24 : Fri Dec 15 2000 - 15:31:05 MST