Subject: Farallon 10/100 the answer?
From: Jeff Tupholme (jeff.tupholme@openmethods.com)
Date: Thu Feb 01 2001 - 00:11:39 MST
Picking up this thread from a couple of months ago...
I have just re-installed YDL CS 1.2 on my PowerCenterPro 210, now with
Farallon NetLINE 10/100 PCI card (PN993-TX) installed.
The card was not mentioned during the network stage of the installation
process (the background console showed that eth0 was being used), but
during boot-up of the working system it is shown as eth1. If if use
ifconfig, I see eth0 and lo but no eth1.
I am not sure if this qualifies as a success or not! At least the card is
detected and recognised. I think there is something I should do to
configure the system to make it available (i.e., so I can see it in
ifconfig), because as I understand it I could then start to use it (e.g.,
in route configuration).
Any advice on the right next step, and how to take it, would be much
appreciated.
Thanks,
Jeff
>Mime-Version: 1.0
>X-Sender: jeglinx@206.6.156.11
>Date: Mon, 27 Nov 2000 10:42:35 -0500
>To: Jeff Tupholme <jeff.tupholme@openmethods.com>
>From: Stefan Jeglinski <jeglin@4pi.com>
>Subject: Re: eth0 dies by ping - Farallon 10/100 tha answer?
>
>>I am planning to re-install once more, after I figure out all the
>>application configurations (Samba the the moment!), so I'll try doing that
>>with my Farallon card installed and see if that works also.
>
>Please let the list know what success (or not) you have with the
>Farallon 10/100.
>
>
>Stefan Jeglinski
_____________________________________
Jeff Tupholme, Open Methods Limited
email: jeff.tupholme@openmethods.com
AIM: jefftupholme
mobile: +44 (0)7973 172626
office: +44 (0)870 076 6000
This archive was generated by hypermail 2a24 : Thu Feb 01 2001 - 00:14:01 MST