Subject: Re: eth0 not working with DHCP
From: Philip Good (phil@go2taichi.com)
Date: Fri Feb 09 2001 - 14:12:04 MST
How are you configuring your eth0? By hand, linuxconf, netcfg? linuxconf
tends to be incomplete in this area (I've found).
Launch netcfg from the shell, deactivate the eth0, then re-activate
eth0, you should see some messages on the shell screen which may help.
Also, if you have access to the server running dhcpd, you could do:
tail -f /var/log/messages
and look for the DHCP reconnection.
Check to make sure that the Default Gateway under Routing is correct.
This got me one time, you don't get any errors but can't connect. Also,
try
/etc/rc.d/init.d/network restart
and see what you get.
Good luck
Phil
> Hi all,
>
> I have recently installed YDL on Mac 7500 - with no non-standard
> components - and have configured Ethernet port for DHCP. YDL is
staight
> off the 1.2.1 CD with no updated RPMs
>
> When connected to the LAN with DHCP server I get IP address assigned,
> gateways and DNS server addresses configured correctly but am unable
to
> ping anything on network, nor can my Mac be pinged from elsewhere.
> Unsurprisingly, nothing else works over Ethernet either.
>
> Network card is OK - it works with MacOS and must have talked to the
> DHCP server under YDL to get the IP address etc. If I restart with no
> LAN then eth0 fails to init and I get no IP address which proves the
> address was assigned by connecting to DHCP server.
>
> Can anyone suggest how I diagnose/treat this ailment?
>
> Thanks.
>
> Paul.
>
>
>
>
-- Philip Good Red Planet Development, Red Canyon Software, Good Chi Tai Chi
This archive was generated by hypermail 2a24 : Fri Feb 09 2001 - 14:13:24 MST