Subject: Re: Re: eepro100 2.4.18
From: Rúni "H.Hansen (runi.hansen@okkara.net)
Date: Tue Feb 19 2002 - 11:59:34 MST
Yes I mean menuconfig or xconfig. if you dont see the eepro100
(EtherExpressPro/100", it is probably because you dont have "EISA, VLB,
PCI and board controlles" checked. I have 2.4.18-rc1 and I can see
eepro100
/Rúni
On Tue, 2002-02-19 at 19:01, duanestites@cox.net wrote:
> Do you mean I need to do this in menuconfig and then rebuild my kernel? Also I the eepro100 was no listed a a driver in menuconfig, but it is in the driver/net directory that I am building the kernel from. Does it have to be selected as a module when I make the kernel, or can it be added later on? If it has to be compiled how would I make it show in menuconfig?
>
> Thanks
> Duane
> >
> > From: "Runi H.Hansen" <runi.hansen@okkara.net>
> > Date: 2002/02/19 Tue AM 02:34:47 EST
> > To: yellowdog-general@lists.yellowdoglinux.com
> > Subject: Re: eepro100 2.4.18
> >
> > I belive if you set "Set version information on all module systems" to
> > No,in "Loadable module support" It should work. Dont ask my why ;o)
> >
> > /Rúni
> >
> > On Tue, 2002-02-19 at 08:09, Duane Stites wrote:
> > > I upgraded my kernel to 2.4.18-rc1-benh and I am now unable to get my Intel
> > > pro 100 card to come online. When I run insmod or modprobe eepro100.o I get
> > > a page full of Undefined Symbols.
> > >
> > > I downloaded the driver from ftp://ftp.scyld.com/pub/network/ and tried to
> > > compile it but I get "initializer element not found.
> > >
> > > I am on a 7200/120 running YD2.1. Does any one have any ideas on what else
> > > I could try?
> > >
> > > Thanks,
> > > Duane
> >
> >
> >
This archive was generated by hypermail 2a24 : Tue Feb 19 2002 - 12:16:38 MST