Subject: Airport Card / Airport Help Needed
From: Robert Angell (Bob.Angell@us.ibm.com)
Date: Tue Jan 29 2002 - 02:41:56 MST
Folks,
I have gone through both documents outlining how to get the Airport
Card/Airport working
with little to no luck - I have used both 2.2 / 2.4 kernel docs.
Here is my setup as follows:
tiBook G4 400 w/768MB Ram
Airport Card installed
(2) Airport Base Stations - ANY 10.0.0.3 channel 3/HOME1 10.0.0.37
channel 9
I would like to be able to detect/use both of the above, but would be happy
with either.
Here is what I did as follows:
cd /etc/sysconfig/network-scripts
cp ifcfg-eth0 ifcfg-eth1
edited ifcfg-eth1
/sbin/modprobe airport
/etc/rc.d/init.d/network stop
/etc/rc.d/init.d/network start
I keep getting 0.0.0.0 routes in my routing table ... and after I clean
them out, it still is not
working.
Anyone have similiar problems and potential work arounds??
Thanks.
-Bob-
Bob Angell
Technical Solution Manager - IBM Global Services
1238 Fenway Ave., SLC, Ut 84102-3212
v/f: 801-328-6157 (t/l 582); cell/pager: 801-381-5477
email page < 140 char: mailto:8013815477@page.nextel.com;
http://messaging.nextel.com/cgi/mPageExt.dll?buildIndAddressPage&entry=1
regular email: angellr@us.ibm.com
[ mailto:angellr@us.ibm.com ] [
http://w3.ibm.com/bluepages?Selection=Name&selectOn=angell%2Cbob ]
"Had Momma Cass & Karen Carpenter shared that ham sandwich, they might be
with us today!"
This archive was generated by hypermail 2a24 : Tue Jan 29 2002 - 02:57:42 MST