Subject: Re: Ethernet/DHCP
From: coyote (coyote@iktome.com)
Date: Fri Jul 13 2001 - 15:21:05 MDT
Thanks everybody!
I have it up and running by getting the router address from my DHCP connection info.
I AM running ATT, so I may need to do some more looking as things move on, but
for now things are peachy keen.
Thanks again.
T
>Tom,
>If you run ATT, look in the booklet that theyprovided when installing
>the software for th first time. There should be directions on how to
>install your linux settings.
>
>good luck.
>
>Kris
>
>>YDL is installed on an iMac DV and I had no prblems in that installation...
>>BUT...
>>
>>I cannot seem to get it to recognize my cable modem set up.
>>
>>I run a DHCP server but if I specify DHCP in the networking protocol I do
>>not have anyway to specify the DHCP client ID.
>>
>>Any suggestions?????
>>
>>Thanks,
>>
>>Tom
>>--
>>I've had a wonderful evening, this just wasn't it.
>> - Groucho Marx
>>
>>---------------------------------------------------
>>
>>Tom Butler
>>Iktome MediaWorks
>>800 W. Napa Street
>>PMB#42
>>Sonoma, CA 954676
>>707-778-7234
>>Fax: 888-654-3643
>>
>
>--
>KRISNADI POEDJOSOEDARMO
>Children's Hospital Oakland Research Institute
>Tel: (510) 428-3885 ext. 2643
This archive was generated by hypermail 2a24 : Fri Jul 13 2001 - 14:26:45 MDT