Subject: Re: Cable Modem not seen on install
From: cdowns (cdowns@skillsoft.com)
Date: Sun Jul 22 2001 - 21:02:00 MDT
i believe the module that the starmax used is a tulip.o module. open a shell
and type: insmod tulip if you dont see any errors it is the correct module.
then type: pump
see if you get and network address by typing: ifconfig eth0 then of course you
can ping to test network activity.
good luck
-D
Lee Moffitt wrote:
> I'm a Newbie - just bought YDL 2 at MacWorld, and installed it without much
> trouble. Only two big problems - any help would be appreciated.
>
> 1. I have a cable modem (3Com), on the other side of a PCI Ethernet card.
> When I installed YDL, the installation program said it couldn't find a
> network device. So I can't get Ethernet access. Any idea what went wrong, or
> what I need to do?
>
> 2. I have a Zip drive (SCSI) that was included in the configuration (sdb).
> How do I mount the Zip drive? Guess I at least need to know the "type" of
> file system on the drive for the mount command (?).
>
> I am running a Motorola StarMax 3000/180, accelerated to 300 MHz with a
> Sonnet Crescendo upgrade card.
>
> Thanks much!
This archive was generated by hypermail 2a24 : Sun Jul 22 2001 - 16:14:25 MDT