Subject: Re: contour design unimouse on '99 G3 pbook w/YDLCS 1.1
From: Dan Burcaw (dburcaw@terraplex.com)
Date: Sat Jan 08 2000 - 00:03:22 MST
The unimouse should work fine with the stock 2.2.6 kernel.
> B <grisinge@cs.colostate.edu> writes:
> >I went in circles following dead links and bad instructions with that
> >too. Try this mouseconfig:
> >ftp://ftp.yellowdoglinux.com/pub/yellowdog/software/mouseconfig/mousec
> >onfig-4.0-1a.ppc.rpm .
> >It seemed to work great for me. Before that I could get nothing to
> >work. As a note I am using 2.2.14pre16-imac. I just installed the
> >above rpm then ran mouseconfig. Check out
> >http://devel.yellowdoglinux.com/rp_kernel.shtml where it talks about
> >USB keyboard an mouse configuration.
>
> I had seen that page too, but it looked like it was describing what
> to do after you've upgraded the kernel to a later version. Clearly you
> have done that, so that makes sense for you. But is there any way to
> get the unimouse to work with the 2.2.6 kernel, the one that comes with
> YDLCS 1.1?
>
> I have no problem with upgrading to a newer version of the kernel, but
> when debugging I like to try to make minimal changes from a configuration
> that is supposed to work, lest new problems creep in. Is the unimouse
> supposed to work with the Champion Server 1.1 default kernel, or isn't it?
> If I must upgrade the kernel then I will, but I'd like to know whether
> I must.
>
> -David Covin
> david@drozd.uchicago.edu
>
Dan
Terra Soft Solutions, Inc.
Yellow Dog Linux
"The Ultimate Companion for a Dedicated Server"
http://www.yellowdoglinux.com/
This archive was generated by hypermail 2a24 : Tue Feb 01 2000 - 17:50:57 MST