Graham Leggett (minfrin@sharp.fm)
Mon, 12 Jul 1999 18:46:33 +0200
Graham Leggett wrote:
> During bootup the configuration of eth0 fails complaining that the
> command /sbin/pump cannot be found. Sure enough, this command is
> missing.
As it turns out, the problem happened after the initscripts package in
the updates directory was installed. This uses a dhcp client called
"pump" to configure networking. The "pump" package however is neither
installed, nor as rpmfind would have it, available for PPC.
Any ideas?
Regards,
Graham
-- ----------------------------------------- minfrin@sharp.fm "There's a moon over Bourbon Street tonight...
This archive was generated by hypermail 2.0b3 on Sat Jul 31 1999 - 11:30:05 MDT