FW: eth0 Warning

Subject: FW: eth0 Warning
From: Simon, Daniel (dsimon@unf.edu)
Date: Mon Dec 18 2000 - 06:20:00 MST

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Next message: Robert J. Bloemeke: "Booting from a slave disc?"
• Previous message: Chuq Von Rospach: "Re: burning ISO disks, also Boot and NFS+?"
• Maybe in reply to: Simon, Daniel: "eth0 Warning"
• Next in thread: Bryan Stillwell: "Re: FW: eth0 Warning"
• Next in thread: Bryn Hughes: "Re: eth0 Warning"
• Maybe reply: Simon, Daniel: "FW: eth0 Warning"

> Hey,
>
> Need some advice. I am getting the following at the end of my
> bootup:
>
> eth0 PHY ID: 0x00206047
> eth0 Warning ! Unsupported BCM5400 PHY !
>
>
> Then I get:
>
> eth0 PHY reset timeout
> eth0 Warning ! Can't find PHY
>
> about 5 - 6 times over.
>
>
> I am using a G4 -- I of course don't get IP or any network protocols.
> Can't ping, etc.
> Any advice would be great.
>
> Thanks,
>
> Dan Simon
>
>

• Next message: Robert J. Bloemeke: "Booting from a slave disc?"
• Previous message: Chuq Von Rospach: "Re: burning ISO disks, also Boot and NFS+?"
• Maybe in reply to: Simon, Daniel: "eth0 Warning"
• Next in thread: Bryan Stillwell: "Re: FW: eth0 Warning"
• Next in thread: Bryn Hughes: "Re: eth0 Warning"
• Maybe reply: Simon, Daniel: "FW: eth0 Warning"

This archive was generated by hypermail 2a24 : Mon Dec 18 2000 - 06:35:39 MST