Subject: Installation - Error: Mount failed:Invalid Arguments
From: Josh Smith (irilyth@infersys.com)
Date: Sun Jun 25 2000 - 13:11:24 MDT
This should probably be in a FAQ somewhere...
If you're continuing with the installation after partitioning the drive, and
getting "mount failed" errors, try this: Run fdisk at the usual time, edit
the partition map, write the map, get the warning message, quit from fdisk,
reboot, and then run through the initial configuration up the fdisk part,
but this time just do "Done" at the Partition Disks dialog box (rather than
"fdisk"). On the following "Current Disk Partitions" screen, all the
partitions should appear (the ones that you set up the first time through).
See if that does the trick for you...
-Josh (irilyth@infersys.com)
This archive was generated by hypermail 2a24 : Sun Jun 25 2000 - 13:13:20 MDT